🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
AWWA C903 2005

AWWA C903 2005

$75.83

AWWA C903-05: Polyethylene-Aluminum-Polyethylene Crosslinked Polyethylene Composite Pressure Pipes 1/2″ (12 MM) Through 2″ (50 MM) For Water Service

Published By Publication Date Number of Pages
AWWA 2005 32
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This standard describes coextruded polyethylene (PE) composite pressure pipes with a welded aluminum tube reinforcement between the inner and outer layers of polyethylene, primarily for use as underground water service lines.

PDF Catalog

PDF Pages PDF Title
1 ANSI/AWWA C903-05
3 Committee Personnel
5 Contents
7 Foreword
I. Introduction.
9 II. Special Issues.
11 Table F.1 Calculated surge pressures for an instantaneous change in velocity of
1 ft/sec (0.3048 m/sec) in PE–AL–PE or PEX–AL–PEX pipe
13 Table F.2 Minimum bending radius for PE–AL–PE and PEX–AL–PEX pipe
14 III. Use of This Standard.
15 IV. Major Revisions.
V. Comments.
17 AWWA Standard Polyethylene–Aluminum–Polyethylene and
Cross-linked Polyethylene–Aluminum–
Cross-linked Polyethylene Composite Pressure
Pipes

SECTION 1: GENERAL
Sec. 1.1 Scope
18 Sec. 1.2 Purpose
Sec. 1.3 Application
SECTION 2: REFERENCES
19 SECTION 3: DEFINITIONS
20 SECTION 4: REQUIREMENTS
Sec. 4.1 Permeation
21 Sec. 4.2 Basic Materials
Table 1 PE materials—inner and outer layers*
Table 2 Melt adhesive*
22 Table 3 Outside diameters, aluminum thickness, and tolerances
Sec. 4.3 Pipe Requirements
23 Table 4 Pipe wall thickness
24 Table 5 Minimum burst pressure and sustained pressure for PE–AL–PE pipe
Table 6 Minimum burst pressure and sustained pressure for PEX–AL–PEX pipe
25 Table 7 Pressure design basis (PDB) and pressure rating (PR)
Sec. 4.4 Pressure Rating (PR) of Pipe
SECTION 5: VERIFICATION
Sec. 5.1 General
26 Sec. 5.2 Tests for Qualification of Materials and Processes
Sec. 5.3 Tests for Product Quality Control
Sec. 5.4 Action After Failure to Meet Requirements
Sec. 5.5 Quality Control Records
27 Sec. 5.6 Plant Inspection by the Purchaser
SECTION 6: DELIVERY
Sec. 6.1 Marking
28 Sec. 6.2 Shipping and Delivery
Sec. 6.3 Affidavit of Compliance

Related products

AWWA C903 2005
$75.83