ASTM-A334 2004

$40.63

A334/A334M-04a Standard Specification for Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service

Published By	Publication Date	Number of Pages
ASTM	2004	6

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A334/A334M-04a

Historical Standard: Standard Specification for Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service

ASTM A334/A334M

Scope

1.1 This specification covers several grades of minimum-wall-thickness, seamless and welded, carbon and alloy-steel tubes intended for use at low temperatures. Some product sizes may not be available under this specification because heavier wall thicknesses have an adverse affect on low-temperature impact properties.

1.2 Supplementary Requirement S1 of an optional nature is provided. This shall apply only when specified by the purchaser.

Note 1—For tubing smaller than 1/2 in. [12.7 mm] in outside diameter, the elongation values given for strip specimens in Table 1 shall apply. Mechanical property requirements do not apply to tubing smaller than 1/8 in. [3.2 mm] in outside diameter and with a wall thickness under 0.015 in. [0.4 mm].

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.

Keywords

seamless carbon; welded carbon; alloy-steel tubes; low-temperature service

ICS Code

ICS Number Code n/a

DOI: 10.1520/A0334_A0334M-04A

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Ordering Information General Requirements Materials and Manufacture Heat Treatment
2	Chemical Composition Product Analysis Sampling TABLE 1 TABLE 2
3	Tensile Requirements Hardness Requirements Impact Requirements TABLE 3
4	Mechanical Tests Specimens for Impact Test Impact Test TABLE 4 TABLE 5
5	Hydrostatic or Nondestructive Electric Test Product Marking TABLE 6 TABLE 7
6	X1. DETERMINATION OF TEMPERATURE REDUCTIONS X1.1

Additional information

Standard Title	A334/A334M-04a Standard Specification for Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service
Published Code	ASTM
Publication Date	2004
Pages Count	6