ASTM-A450 2007
$40.63
A450/A450M-07 Standard Specification for General Requirements for Carbon and Low Alloy Steel Tubes
| Published By | Publication Date | Number of Pages |
| ASTM | 2007 | 10 |
1.1 This specification covers a group of requirements which, with the exceptions of 5.3 and Sections6, 7, 18, 19, 20, 21, 22, 23, and 24, are mandatory requirements to the following ASTM tubular product specifications:
Title of Specification ASTM Designation Electric-Resistance-Welded Carbon Steel and Carbon Manganese Steel Boiler Tubes A 178/A 178M Seamless Cold-Drawn Low-Carbon Steel Heat-Exchanger and Condenser Tubes A 179/A 179M Seamless Carbon Steel Boiler Tubes for High-Pressure Service A 192/A 192M Seamless Medium-Carbon Steel Boiler and Superheater Tubes A 210/A 210M Electric-Resistance-Welded Carbon Steel Heat-Exchanger and Condenser Tubes A 214/A 214M Seamless and Electric-Welded Low-Alloy Steel Tubes A 423/A 423M Seamless Cold-Drawn Carbon Steel Feedwater Heater Tubes A 556/A 556M Seamless, Cold-Drawn Carbon Steel Tubing for Hydraulic System Service A 822/A 822M These designations refer to the latest issue of the respective specifications.
1.2 One or more of Sections , , , , , , , , , and apply when the product specification or purchase order has a requirement for the test or analysis described by these sections.
1.3 In case of conflict between a requirement of the product specification and a requirement of this general requirement specification only the requirement of the product specification need be satisfied.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the ‘M’ designation (SI) of the product specification is specified in the order.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents |
| 2 | Terminology Process Chemical Composition Tensile Properties |
| 3 | Standard Weights Permissible Variations in Wall Thickness Permissible Variations in Outside Diameter Permissible Variations in Length TABLE 1 TABLE 2 TABLE 3 TABLE 4 |
| 4 | Permissible Variations in Height of Flash on Electric-Resistance-Welded Tubes Straightness and Finish Repair by Welding Retests Retreatment Test Specimens Method of Mechanical Testing Flattening Test Reverse Flattening Test |
| 5 | Flaring Test Flange Test Hardness Test Hydrostatic Test TABLE 5 TABLE 6 TABLE 7 |
| 6 | Air Underwater Pressure Test Nondestructive Examination |
| 8 | Certified Test Report Inspection Rejection Product Marking Packaging, Marking, and Loading Government Procurement |
| 9 | Keywords TABLE 8 |
