ASTM-A844 2009

$35.75

A844/A844M-09 Standard Specification for Steel Plates, 9 % Nickel Alloy, for Pressure Vessels, Produced by the Direct-Quenching Process

Published By	Publication Date	Number of Pages
ASTM	2009	3

Guaranteed Safe Checkout

Categories: 77.140.30 - Steels for pressure purposes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers 9 % nickel-alloy steel plates produced by the direct-quenching process. The plates are intended primarily for use in welded pressure vessels.

1.2 The direct-quenching process consists of quenching the plates directly after rolling, without permitting the plates to cool below the critical temperature prior to initiation of the quenching operation, and subsequently tempering the plates. (This differs from the conventional process in which the plates are permitted to cool to a temperature significantly below the critical temperature, usually to ambient temperature, prior to reheating to a temperature above the upper critical temperature, then quenching, and subsequently tempering.)

1.3 The maximum nominal thickness of plates furnished under this specification shall not exceed 2 in. [50 mm].

1.4 This material is susceptible to magnetization. Use of magnets in handling after heat treatment should be avoided if residual magnetism would be detrimental to subsequent fabrication or service.

1.5 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents General Requirements and Ordering Information Manufacture
2	Chemical Composition Finish Mechanical Requirements Marking Keywords TABLE 1 TABLE 2

Additional information

Standard Title	A844/A844M-09 Standard Specification for Steel Plates, 9 % Nickel Alloy, for Pressure Vessels, Produced by the Direct-Quenching Process
Published Code	ASTM
Publication Date	2009
Pages Count	3
ICS Codes	77.140.30 - Steels for pressure purposes

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-A844 2009

PDF Catalog

Related products