ASTM-D2737 2003

$40.63

D2737-03 Standard Specification for Polyethylene (PE) Plastic Tubing

Published By	Publication Date	Number of Pages
ASTM	2003	7

Guaranteed Safe Checkout

Categories: 23.040.20 - Plastics pipes, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This specification covers polyethylene (PE) tubing pressure rated for water (see appendix). Included are criteria for classifying PE plastic tubing materials and PE plastic tubing, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, and environmental stress cracking. This specification differs from the pipe specifications in their outside diameters. Methods of marking are also given.

1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

Note 1PE plastic tubing is often used with fittings that require flaring the tubing. The technique used to make the flare is highly important to produce leak-free joints. For further information, refer to Practice D 3140.

1.4 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Tubing Classification Materials Requirements TABLE 1
3	Test Methods TABLE 2 TABLE 3 TABLE 4
4	TABLE 5
5	Retest and Rejection Marking TABLE 6
6	Quality Assurance X1. SOURCE OF HYDROSTATIC DESIGN STRESSES X1.1 X1.2 X1.3 X1.4 X1.5 TABLE X1.1

Additional information

Standard Title	D2737-03 Standard Specification for Polyethylene (PE) Plastic Tubing
Published Code	ASTM
Publication Date	2003
Pages Count	7
ICS Codes	23.040.20 - Plastics pipes

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-D2737 2003

PDF Catalog

Related products