ASTM-D3326 2024

$34.13

D3326-07(2024) Standard Practice for Preparation of Samples for Identification of Waterborne Oils

Published By	Publication Date	Number of Pages
ASTM	2024

Guaranteed Safe Checkout

Category: ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D3326-07-Reapproved2024

Active Standard: Standard Practice for Preparation of Samples for Identification of Waterborne Oils

ASTM D3326

Scope

1.1 This practice covers the preparation for analysis of waterborne oils recovered from water. The identification is based upon the comparison of physical and chemical characteristics of the waterborne oils with oils from suspect sources. These oils may be of petroleum or vegetable/animal origin, or both. Seven procedures are given as follows:

1.2 Procedures for the analytical examination of the waterborne oil samples are described in Practice D3415 and Test Methods D3328, D3414, and D3650. Refer to the individual oil identification test methods for the sample preparation method of choice. The deasphalting effects of the sample preparation method should be considered in selecting the best methods.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific caution statements are given in Sections 6 and 32.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

identification; oil spill; preparation; sample; waterborne oil;

ICS Code

ICS Number Code 75.080 (Petroleum products in general)

DOI: 10.1520/D3326-07R24

Additional information

	Sections
Procedure B (for samples containing significant quantities of hydrocarbons with boiling points above 280 °C)	13 to 17
Procedure C (for waterborne oils containing significant amounts of components boiling below 280 °C and to mixtures of these and higher boiling components)	18 to 22
Procedure A (for samples of more than 50 mL volume containing significant quantities of hydrocarbons with boiling points above 280 °C)	8 to 12
Procedure F (for thin films of oil-on-water)	35 to 39
Procedure E (for samples of light crudes and medium distillate fuels)	28 to 34
Procedure G (for oil-soaked samples)	40 to 44
Procedure D (for samples containing both petroleum and vegetable/animal derived oils)	23 to 27