ASTM-D6262 2005

$40.63

D6262-05 Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK) (Withdrawn 2010)

Published By	Publication Date	Number of Pages
ASTM	2005	9

Guaranteed Safe Checkout

Categories: 83.140.99 - Other rubber and plastics products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM D6262-05

Historical Standard: Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK) (Withdrawn 2010)

ASTM D6262

Scope

1.1 This specification covers requirements and methods of test for the material, dimensions, and workmanship, and the properties of extruded, compression molded, and injection molded PAEK sheet, plate, rod, and tubular bar manufactured from PAEK.

1.2 The properties included in this specification are those required for the compositions covered. Requirements necessary to identify particular characteristics important to specialized applications may be described by using the classification system given in Section 4.

1.3 This specification allows the use of key clad plastics² (see Section 4).

1.4 The values are stated in inch-pound units and are regarded as the standard in all property and dimensional tables. For reference purposes, SI units are also included in Table 1.

1.5The following precautionary caveat pertains only to the test method portion Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no similar or equivalent ISO standard.

Keywords

PAEK; plates-PAEK; recycled-PAEK; recycled plastic; rod-PAEK; shapes-PAEK; sheet-PAEK; tubular bar-PAEK

ICS Code

ICS Number Code 83.140.99 (Other rubber and plastic products)

DOI: 10.1520/D6262-05

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology
2	Classification and Material Physical Property Requirements Dimensional Requirements Workmanship, Finish, and Appearance
3	Sampling Number of Tests Test Conditions Test Methods
4	Certification Packing, Packaging, and Marketing Ordering Information Keywords

Additional information

Standard Title	D6262-05 Standard Specification for Extruded, Compression Molded, and Injection Molded Basic Shapes of Poly(aryl ether ketone) (PAEK) (Withdrawn 2010)
Published Code	ASTM
Publication Date	2005
Pages Count	9
ICS Codes	83.140.99 - Other rubber and plastics products