ASTM-E1545:2005 Edition

$35.75

E1545-05 Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis

Published By	Publication Date	Number of Pages
ASTM	2005	4

Guaranteed Safe Checkout

Categories: 81.040.01 - Glass in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E1545-05

Historical Standard: Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis

ASTM E1545

Scope

1.1 This test method describes procedures for the assignment of the glass transition temperature of materials on heating using thermomechanical measurements under prescribed experimental conditions.

1.2 This test method is applicable to amorphous or to partially crystalline materials that are sufficiently rigid below the glass transition to inhibit indentation by the sensing probe.

1.3 The normal operating temperature range is from 100 to 600°C. This temperature range may be extended depending upon the instrumentation used.

1.4 SI units are the standard.

1.5 This test method is related to ISO 11359-2. ISO 11359-2 additionally covers the determination of coefficient of linear thermal expansion not covered by this test method. This test method is related to IEC 61006 but uses a slower heating rate.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7.

Keywords

glass transition T g; linear thermal expansion; softening point T s; thermodilatometry; thermomechanical analysis (TMA)

ICS Code

ICS Number Code 81.040.01 (Glass in general)

DOI: 10.1520/E1545-05

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method Significance and Use
2	Apparatus Hazards FIG. 1
3	Sampling Calibration Procedure Calculation Report
4	Precision and Bias Keywords FIG. 2

Additional information

Standard Title	E1545-05 Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis
Published Code	ASTM
Publication Date	2005
Pages Count	4
ICS Codes	81.040.01 - Glass in general