BS 7363:1990:2004 Edition
$102.76
Method for bead-on-plate (BOP) test for welds
| Published By | Publication Date | Number of Pages |
| BSI | 2004 | 16 |
This British Standard describes the bead-on-plate (BOP) test for welds. These are intended for investigating the welding of carbon, carbon-manganese and low-alloy steels.
Tests are normally performed for the evaluation of parent material characteristics. Tests may also be used to investigate welding consumables and welding parameters.
NOTE The titles of the publications referred to in this standard are listed on the inside back cover.
Two tests intended for investigating the welding of carbon, carbon-manganese and low-alloy steels. The CTS test is used for determining the extent of susceptibility to heat affected zone (HAZ) hydrogen cracking and the BOP test is used to investigate HAZ hardening behaviour.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 2 | Committees responsible for this British�Standard |
| 3 | Contents |
| 5 | General Scope Definitions Measurements Material for test pieces |
| 7 | Deleted |
| 9 | BOP test Application Test piece form Welding General Preparation and preheat Test piece type Welding the type 1 standardized BOP test |
| 10 | Welding conditions for the standardized BOP test Welding the type 2, discretional welding conditions BOP test Cooling of the test piece Hardness testing Recording of results |
| 11 | Details of test plate and sectioning for BOP test Location of hardness impressions for BOP test |
| 12 | Deleted Deleted |
| 13 | Typical TRS for BOP test Typical TRS for BOP test |
