BS EN 61169-35:2011
$142.49
Radio-frequency connectors – Sectional specification for 2,92 series RF connectors
| Published By | Publication Date | Number of Pages |
| BSI | 2011 | 30 |
IEC 61169-35:2011 provides information and rules for preparation of detail specification of 2,92 series RF coaxial connectors together with the pro-forma blank detail specification. It also prescribes mating face dimensions for high performance connectors – grade 1, dimensional detail of standard test connectors – Grade 0, gauging information and tests selected from IEC 61169-1 applicable to all detail specifications relating to 2,92 series RF coaxial connectors. It cancels and replaces IEC/PAS 61169-35, published in 2009, of which it constitutes a minor revision. The only change is that the PAS has been changed into and International Standard.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | CONTENTS |
| 8 | FOREWORD |
| 10 | 1 Scope 2 Normative references 3 Mating face and gauge information 3.1 Dimensions – High performance connectors – Grade 1 |
| 11 | Figures Figure 1 – Connector with pin-centre contact (for dimensions and notes, see Table 1) Tables Table 1 – Dimensions of connector with pin-centre contact |
| 12 | Figure 2 – Connector with socket-centre contact (for dimensions and notes, see Table 2) Table 2 – Dimensions of connector with socket-centre contact |
| 13 | 3.2 Gauges Figure 3 – Gauge pins for socket-centre contact (for dimensions and notes, see Table 3) Table 3 – Dimensions of gauge pins for socket-centre contact |
| 14 | 3.3 Dimensions – standard test connectors – Grade 0 Figure 4 – Connector with pin-centre contact (for dimensions and notes, see Table 4) Table 4 – Dimensions of connector with pin-centre contact |
| 15 | 4 Quality assessment procedure 4.1 General Figure 5 – Connector with socket-centre contact (for dimensions and notes, see Table 5) Table 5 – Dimensions of connector with socket-centre contact |
| 16 | 4.2 Rating and characteristics (see Clause 6 of IEC 61169-1) Table 6 – Rating and characteristics |
| 18 | 4.3 Test schedule and inspection requirements – Acceptance tests Table 7 – Acceptance tests |
| 19 | Table 8 – Periodic tests |
| 20 | 4.4 Procedures |
| 21 | 5 Instructions for preparation of detail specifications 5.1 General 5.2 Identification of the detail specification 5.3 Identification of the component 5.4 Performance |
| 22 | 5.5 Marking, ordering information and related matters 5.6 Selection of tests, test conditions and severities |
| 23 | 5.7 Blank detail specification pro forma for 2,92 series connectors |
| 28 | Bibliography |
