BSI PD CEN/TR 16748:2014
$142.49
Aluminium and aluminium alloys. Mechanical potential of Al-Si alloys for high pressure, low pressure and gravity die casting
| Published By | Publication Date | Number of Pages |
| BSI | 2014 | 26 |
This Technical Report presents the characteristics of reference dies and reference castings, to be used for evaluating the mechanical potential (in terms of Ultimate Tensile Strength, Yield Strength and Elongation) which can be expected by Al-Si based alloys, cast by high pressure, low pressure and gravity (permanent mould) processes. These properties are measured on separately cast test specimens produced with state-of-the-art knowledge on die design, process management and alloy treatments correctly applied to minimize defects and imperfections.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 5 | Foreword |
| 6 | 1 Scope 2 Normative references 3 Terms and definitions |
| 7 | 4 Reference dies 4.1 Reference dies for high pressure die cast Al-Si alloys 4.1.1 HPDC reference die #1 |
| 9 | 4.1.2 HPDC reference die #2 |
| 10 | Figure 2 — HPDC Reference casting #2 4.2 Reference dies for low pressure and gravity die cast Al-Si alloys 4.2.1 Gravity casting Reference die #1 Figure 3 — Gravity casting reference die #1 |
| 11 | 4.2.2 Gravity casting Reference die #2 Figure 4 — Gravity casting Reference die #2 4.2.3 Gravity casting Reference die #3 |
| 12 | Figure 5 — Reference gravity casting #3 4.2.4 LPDC reference die Figure 6 — LPDC Reference casting 5 Definition of mechanical potential of Al-Si die cast alloys 5.1 General |
| 13 | 5.2 Tensile tests 5.3 Test pieces |
| 14 | Figure 7 — Specimens cut from high pressure die casting reference casting #1 |
| 15 | Figure 8 — Specimens cut from high pressure die casting reference casting #2 Figure 9 — Specimen drawn from gravity die casting reference casting #1 |
| 16 | Figure 10 — Specimen drawn from gravity die casting reference casting #2 5.4 Rounding rules for determination of compliance 5.5 Mechanical potential Table 1 — Template for indication of mechanical potential of Al-Si cast alloys |
| 17 | Annex A (informative) Mechanical potential of Al-Si based alloys for high pressure and gravity die casting: Examples of reference dies and castings A.1 High pressure die casting A.1.1 Reference casting #1 [1] Table A.1 — Composition of the alloys evaluated |
| 18 | Table A.2 — Mechanical Potential of some Al-Si high pressure die cast alloys (HPDC Reference die #1) |
| 20 | A.1.2 Reference casting #2 [3] Table A.3 — Composition of the alloy evaluated |
| 21 | Table A.4 — Mechanical Potential of AlSi7MgMn high pressure die cast alloy (HPDC Reference die #2) Figure A.2 — Engineering stress-strain curve of diecast AlSi7Mg0.3 alloy A.2 Gravity die casting Table A.5 – Composition of the alloy evaluated |
| 22 | Table A.6 — Mechanical Potential of one Al-Si gravity die cast alloy (Gravity reference die #3) |
| 24 | Bibliography |
