Shopping Cart

No products in the cart.

IEEE 269 1993

$63.38

IEEE Standard Methods for Measuring Transmission Performance of Analog and Digital Telephone Sets

Published By Publication Date Number of Pages
IEEE 1993 38
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Revision Standard – Inactive – Superseded. Superseded by IEEE Std 269-2002. Practical methods for measuring the transmission characteristics of both digital and conventional to wire analog telephone sets by means of objective measurements on a test connection are described. The test results thus obtained may be used as a means of evaluating or specifying the transmission performance of a telephone set on a standardized basis. The measurements are applicable to telephone sets incorporating carbon or linear transmitters. Measurements are over the frequency range most useful for speech: 100-5000 Hz. The test methods are not intended to be applicable to special devices, such as noise-exclusion transmitters, distant-talking transmitters, insert-type receivers, or noise-exclusion receivers equipped with large ear pads. You will receive an email from Customer Service with the URL needed to access this publication online.

PDF Catalog

PDF Pages PDF Title
1 Title page
3 Foreword
Participants
5 CONTENTS
7 1. Introduction
2. Scope
8 3. Definitions
10 4. References
11 5. Test Equipment
16 6. Test Procedure for Analog Sets
6.1 General
19 6.2 Standard Circuits
6.3 Transmit
23 6.4 Receive
27 6.5 Sidetone
28 6.6 Overall Transmission
29 6.7 Telephone Set Impedance
6.8 Telephone Set Resistance
30 7. Test Procedures for Digital Sets
7.1 General
7.2 Standard Circuits
7.3 Transmit Frequency Response
7.4 Receive Frequency Response
7.5 Sidetone Frequency Response
7.6 Overall Frequency Response
7.7 Signal-to-Distortion Ratio
33 7.8 Input-Output Linearity
7.9 Noise
7.10 Acoustic Echo Path Loss
7.11 Peak Acoustic Pressure (Steady-State Input)
35 Appendix A— Distortion Using Continuous Spectrum Methods
36 Appendix B—Delay
38 Appendix C—Carbon Transmitter Orientation for Measurements in the AEN Position
IEEE 269 1993
$63.38