🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
JIS B 7726:2017

JIS B 7726:2017

$35.10

Rockwell hardness test – Verification and calibration of testing machines and indenters

Published By Publication Date Number of Pages
JIS 2017-08-21 34
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: , ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This Standard specifies two separate methods of verification of testing machines (direct and indirect) for determining Rockwell hardness in accordance with JIS Z 2245.

This Standard is applicable to stationary and portable Rockwell hardness and Rockwell superficial hardness testing machines (hereafter referred to as testing machines) related to metal materials.

NOTE 1 Attention is drawn to the fact, in ISO 6508-1 : 2015, that the use of tungsten carbide composite for ball indenters (hereafter referred to as hardmetal ball) is considered to be the standard type of Rockwell indenter ball.

Steel indenter balls may continue to be used only when complying with ISO 6508-1, Annex A.

This Standard is intended to adopt hardmetal balls as the standard intenter at the time of next revision

NOTE 2 Attention is drawn to the fact that the result obtained with hardmetal balls may be significantly different from the result obtained with a steel balls

NOTE 3 Rockwell hardnesses are classified into Rockwell regular hardness and Rockwell superficial hardness is ISO 6508-1 while they are respectively described as "Rockwell hardness" and "Rockwell superficial hardness" in this Standard

NOTE 4 The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.

ISO 6508-2 : 2015 Metallic materials – Rockwell hardness test – Part 2 : Verification and calibration of testing machines and indenters (MOD)

In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.

Related products

JIS B 7726:2017
$35.10