This part of IEC 60851 specifies the following tests:<\/p>\n
Test 9: Heat shock;<\/p>\n<\/li>\n
Test 10: Cut-through;<\/p>\n<\/li>\n
Test 15: Temperature index;<\/p>\n<\/li>\n
Test 21: Loss of mass.<\/p>\n<\/li>\n<\/ul>\n
For definitions, general notes on methods of test and the complete series of methods of test for winding wires, see IEC 60851-1.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 6<\/td>\n | English CONTENTS <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | INTRODUCTION <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | 1 Scope 2 Normative references 3 Test 9: Heat shock (applicable to enamelled and tape wrapped wire) 3.1 General 3.2 Specimen 3.2.1 Round wire <\/td>\n<\/tr>\n | ||||||
| 9<\/td>\n | 3.2.2 Rectangular wire 3.3 Procedure 3.4 Result 4 Test 10: Cut-through (applicable to enamelled round wire with a nominal conductor diameter over 0,100\u00a0mm up to and including 1,600\u00a0mm and tape wrapped round wire) 4.1 General 4.2 Equipment 4.3 Procedure Table 1 \u2013 Magnification <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | 5 Test 15: Temperature index 6 Test 21: Loss of mass (applicable to enamelled round wire) 6.1 General 6.2 Specimen 6.3 Procedure Table 2 \u2013 Loads applied to the crossing point <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | Figure 1 \u2013 Compression device for the cut-through test <\/td>\n<\/tr>\n | ||||||
| 13<\/td>\n | Annex A (informative) High temperature failure test (applicable to enamelled round wire) Table A.1 \u2013 Test voltage <\/td>\n<\/tr>\n | ||||||
| 15<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Winding wires. Test methods – Thermal properties<\/b><\/p>\n |