🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-D4935 1999

ASTM-D4935 1999

$40.63

D4935-99 Standard Test Method for Measuring the Electromagnetic Shielding Effectiveness of Planar Materials (Withdrawn 2005)

Published By Publication Date Number of Pages
ASTM 1999 10
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Categories: ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM D4935-99

Historical Standard: Standard Test Method for Measuring the Electromagnetic Shielding Effectiveness of Planar Materials (Withdrawn 2005)

ASTM D4935

Scope

1.1 This test method provides a procedure for measuring the electromagnetic (EM) shielding effectiveness (SE) of a planar material due to a plane-wave, far-field EM wave. From the measured data, near-field SE values may be calculated for magnetic (H) sources for electrically thin specimens. Electric (E) field SE values may also be calculated from this same far-field data, but their validity and applicability have not been established.

1.2 The measurement method is valid over a frequency range of 30 MHz to 1.5 GHz. These limits are not exact, but are based on decreasing displacement current due to decreased capacitive coupling at lower frequencies and on overmoding (excitation of modes other than the transverse electromagnetic mode (TEM)) at higher frequencies for the size of specimen holder described in this test method. Any number of discrete frequencies may be selected within this range. For electrically thin, isotropic materials with frequency-independent electrical properties of conductivity, permittivity and permeability, measurements may be needed at only a few frequencies as the far-field SE values will be independent of frequency. If the material is not electrically thin or if any of the parameters vary with frequency, measurements should be made at many frequencies within the band of interest.

1.3 This test method is not applicable to cables or connectors.

1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Ceramic materials-electrical/electronic devices; Composites-conducting/nonconducting materials; Conductance and conductivity (electrical)-insulating materials; Effectiveness; Electromagnetic testing; Graphite; Metals and metallic materials; Nonmetallic materials; Planar materials; Plast (electrical insulating); Polymers-electrical insulation applications; Resistance and resistivity (electrical)-insulating materials; Semi-conducting materials; Shielding; electromagnetic shielding effectiveness-planar materials, test

ICS Code

ICS Number Code 17.220.20 (Measurement of electrical and magnetic quantities)

DOI: 10.1520/D4935-99

Related products

ASTM-D4935 1999
$40.63