ASTM-E2092 2009

$40.63

E2092-09 Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis

Published By	Publication Date	Number of Pages
ASTM	2009	5

Guaranteed Safe Checkout

Categories: 83.080.01 - Plastics in general, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E2092-09

Historical Standard: Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis

ASTM E2092

Scope

1.1 This test method describes the determination of the temperature at which the specific modulus of a test specimen is realized by deflection in three-point bending. This temperature is identified as the distortion temperature measured. The distortion temperature is that temperature at which a test specimen of defined geometry deforms to a level of strain under applied stress of 0.455 (Method A) and 1.82 MPa (Method B) (66 and 264 psi) equivalent to those used in Test Method D 648. The test may be performed over the range of temperature from ambient to 300°C.

Note 1—This test method is intended to provide results similar to those of Test Method D 648 but are performed on a thermomechanical analyzer using a smaller test specimen. Equivalence of results to those obtained by Test Method D 648 has been demonstrated on a limited number of materials. Until the user demonstrates equivalence, the results of this test method shall be considered to be independent and unrelated to those of Test Method D 648.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

1.4 There is no ISO standard equivalent to this test method.

Keywords

deflection; deflection temperature under load; heat distortion temperature; strain; stress; temperature; thermomechanical analysis (TMA); Deflection; Deflection temperature (under load); Strain testing; Stress; Temperature tests–metals/alloys; Thermomechanical analysis (TMA); Three-point loading

ICS Code

ICS Number Code 83.080.01 (Plastics in general)

DOI: 10.1520/E2092-09

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Terminology Summary of Test Method
2	Significance and Use Apparatus Hazards Sampling FIG. 1
3	Calibration Procedure FIG. 2
4	Calculation Report Precision and Bias FIG. 3
5	Keywords

Additional information

Standard Title	E2092-09 Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis
Published Code	ASTM
Publication Date	2009
Pages Count	5
ICS Codes	83.080.01 - Plastics in general