ASTM-E953 2004
$40.63
E953-88(2004) Standard Test Method for Fusibility of Refuse-Derived Fuel (RDF) Ash
| Published By | Publication Date | Number of Pages |
| ASTM | 2004 | 5 |
ASTM E953-88-Reapproved2004
Historical Standard: Standard Test Method for Fusibility of Refuse-Derived Fuel (RDF) Ash
ASTM E953
Scope
1.1 This test method covers the observation of the temperatures at which triangular pyramids (cones) prepared from RDF ash attain and pass through certain stages of fusing and flow when heated at a specific rate in controlled, mildly-reducing, and oxidizing atmospheres.
1.2 The test method is empirical, and strict observance of the requirements and conditions is necessary to obtain reproducible temperatures and enable different laboratories to obtain concordant results.
1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section for additional hazard information.
Keywords
ICS Code
ICS Number Code 75.160.10 (Solid fuels)
DOI: 10.1520/E0953-88R04
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | Scope Referenced Documents Terminology Significance and Use |
| 2 | Apparatus FIG. 1 FIG. 2 |
| 3 | Hazards Test Atmosphere Preparation of Ash Preparation of Cones |
| 4 | Calibration Procedure |
| 5 | Report Precision and Bias TABLE 1 |
