ASTM-A1000:1999 Edition

$40.63

A1000-99 Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality

Published By	Publication Date	Number of Pages
ASTM	1999	5

Guaranteed Safe Checkout

Categories: 77.140.25 - Spring steels, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A1000-99

Historical Standard: Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality

ASTM A1000

Scope

1.1 This specification covers a quality of round and shaped plain carbon and alloy steel spring wire, uniform in quality and temper, intended for the manufacture of mechanical springs that can withstand moderate fatigue stresses over some relatively low number of cycles. The quality level is between the commercial quality grades of wire such as Specifications A401, A231, and A229 and the valve spring quality grades such Specifications as A230, A232, A877 and A878. It is similar to the grade TD (referenced in EN 10270-2) intended for medium fatigue levels, such as required for clutch springs. This wire shall be either in the annealed and cold-drawn or oil-tempered condition as specified by purchaser.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other.

Keywords

oil-tempered, shaped wire, flat rolled, inclusion content, eddy current, alloy

ICS Code

ICS Number Code 77.140.25 (Spring steels)

DOI: 10.1520/A1000-99

Additional information

Standard Title	A1000-99 Standard Specification for Steel Wire, Carbon and Alloy Specialty Spring Quality
Published Code	ASTM
Publication Date	1999
Pages Count	5
ICS Codes	77.140.25 - Spring steels