ASTM-A626 2008

$40.63

A626/A626M-03(2008)e1 Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced

Published By	Publication Date	Number of Pages
ASTM	2008	5

Guaranteed Safe Checkout

Categories: 77.140.50 - Flat steel products and semi-products, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM A626/A626M-03-e1-Reapproved2008

Historical Standard: Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced

ASTM A626/A626M

Scope

1.1 This specification covers double-reduced electrolytic tin plate produced from low-carbon cold-reduced steel furnished in coils and cut sizes for use predominately in the manufacture of cans. It is furnished in commercially available tin coating weights [masses] and is normally supplied with a trimmed edge.

1.2 This specification is applicable to orders in either inch-pound units (as A 626) which is supplied in thicknesses from 0.0050 to 0.0118 in. or SI units [as A 626M] which is supplied in thicknesses from 0.127 to 0.300 mm.

1.3 The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

coated steel sheet; tin mill products; tin plate; Double-reduced tin mill black plate–specifications; Electrolytic tin plate; Tin mill products–specifications

ICS Code

ICS Number Code 77.140.50 (Flat steel products and semi-products)

DOI: 10.1520/A0626_A0626M-03R08E01

PDF Catalog

PDF Pages	PDF Title
1	Scope Referenced Documents Ordering Information
2	Rolling Direction Tin Coating Weight [Mass] TABLE 1
3	Surface Appearance and Finish FIG. 1
4	Chemical Treatment FIG. 2
5	Oiling General Requirements for Delivery Keywords

Additional information

Standard Title	A626/A626M-03(2008)e1 Standard Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced
Published Code	ASTM
Publication Date	2008
Pages Count	5
ICS Codes	77.140.50 - Flat steel products and semi-products