Shopping Cart

No products in the cart.

ASTM-D7650 2010

$40.63

D7650-10 Standard Test Method for Test Method for Sampling of Particulate Matter in High Pressure Hydrogen used as a Gaseous Fuel with an In-Stream Filter

Published By Publication Date Number of Pages
ASTM 2010 6
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

1.1 This test method is primarily for sampling particulates in hydrogen fuel used in hydrogen fuel cell vehicles or gaseous hydrogen powered internal combustion vehicle engines up to pressures of 35 MPa (350 Bars) using an in-stream filter. This test method describes sampling apparatus design, operating procedures, and quality control procedures required to obtain the stated levels of precision and accuracy.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 The values stated in Bars in 1.1, 7.1 and 10.1.1 are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

PDF Catalog

PDF Pages PDF Title
1 Scope
Referenced Documents
Terminology
Summary of Test Method
2 Significance and Use
Interferences
Apparatus Design
Additional Equipment Needed
3 FIG. 1
4 Reagents and Materials
Hazards
Sampling, Test Specimens, and Test Units
Preparation of Apparatus
Conditioning
5 Procedure
6 Report
Keywords
ASTM-D7650 2010
$40.63