🔥🔥 Don’t Miss Out on Our End of Autumn Sale. If you have any questions, feel free to click the bottom right corner to contact our customer service..

Concat us[email protected]
Shopping Cart

No products in the cart.

🔍
ASTM-E1194:1993 Edition

ASTM-E1194:1993 Edition

$40.63

E1194-87(1993)e1 Standard Test Method for Vapor Pressure

Published By Publication Date Number of Pages
ASTM 1993 7
PDF Format Searchable Printable Preview Now
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

ASTM E1194-87-e1-Reapproved1993

Historical Standard: Standard Test Method for Vapor Pressure

ASTM E1194

Scope

1.1 This test method describes procedures for measuring the vapor pressure of pure liquid or solid compounds. Since no single technique is available to measure vapor pressures from 1 X 10-11 to 100 kPa (approximately 10-10 to 760 torr), two procedures are presented. An isoteniscope (standard) procedure for measuring vapor pressures of liquids from 1 X 10-1 to 100 kPa (approximately 1 to 760 torr) is available in Test Method D2879. A gas-saturation procedure for measuring vapor pressures from 1 X 10-11 to 1 kPa (approximately 10-10 to 10 torr) is presented in this test method. Both procedures are subjects of U.S. Environmental Protection Agency Test Guidelines. This method may not be appropriate for all mixtures.

1.2 These two methods were selected to provide data at normal environmental temperatures (10 to 60oC). At least three temperature values should be studied to allow definition of a vapor pressure-temperature correlation. Values determined should be based on temperature selections such that a measurement is made at 25oC (as recommended by IUPAC) (1), a value can be interpolated for 25oC, or a value can be reliably extrapolated for 25oC. Extrapolation to 25oC should be avoided if the temperature range tested includes a value at which a phase change occurs. Extrapolation to 25oC over a range larger than 10oC should also be avoided. The test methods were selected because of their extended range, simplicity, and general applicability (2). Examples of results produced by the gas-saturation procedure during an interlaboratory evaluation are given in . These data have been taken from Reference (3).

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

gas saturation procedure; isoteniscope procedure; vapor pressure; vapor pressure temperature correlation

ICS Code

ICS Number Code 17.100 (Measurement of force, weight and pressure)

DOI: 10.1520/E1194-87R93E01

Related products

ASTM-E1194
$40.63