ASTM-E643 2024

$34.13

E643-24 Standard Test Method for Ball Punch Deformation of Metallic Sheet Material

Published By	Publication Date	Number of Pages
ASTM	2024

Guaranteed Safe Checkout

Categories: 77.040.10 - Mechanical testing of metals, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

ASTM E643-24

Active Standard: Standard Test Method for Ball Punch Deformation of Metallic Sheet Material

ASTM E643

Scope

1.1 This test method covers the procedure for conducting the ball punch deformation test for metallic sheet materials intended for forming applications. The test applies to specimens with thicknesses between 0.008 in. and 0.080 in. (0.2 mm and 2.0 mm).

Note 1: The ball punch deformation test is intended to replace the Olsen cup test by standardizing many of the test parameters that previously have been left to the discretion of the testing laboratory.

Note 2: The modified Erichsen test has been standardized in Europe. The main differences between the ball punch deformation test and the Erichsen test are the diameters of the penetrator and the dies. Erichsen cup heights are given in SI units.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Keywords

ICS Code

ICS Number Code 77.040.10 (Mechanical testing of metals)

DOI: 10.1520/E0643-24

Additional information

Standard Title	E643-24 Standard Test Method for Ball Punch Deformation of Metallic Sheet Material
Published Code	ASTM
Publication Date	2024
ICS Codes	77.040.10 - Mechanical testing of metals

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-E643 2024

ASTM E643-24

Active Standard: Standard Test Method for Ball Punch Deformation of Metallic Sheet Material

ASTM E643

Related products