AWWA C105 2010

$75.83

AWWA C105-10: Polyethylene Encasement For Ductile-Iron Pipe Systems

Published By	Publication Date	Number of Pages
AWWA	2010	36

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard describes materials and installation procedures for polyethylene encasement to be applied to underground installations of ductile-iron pipe. This standard also may be used for polyethylene encasement of fittings, valves and other appurtenances to ductile-iron pipe systems.

PDF Catalog

PDF Pages	PDF Title
1	ANSI/AWWA C105/A21.5-10
3	Committee Personnel
7	Contents
9	Foreword I. Introduction
11	II. Special Issues.
12	III. Use of This Standard.
13	IV. Major Revisions. V. Comments.
15	AWWA Standard Polyethylene Encasement for Ductile-Iron Pipe Systems SECTION 1: GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose Sec. 1.3 Application
16	SECTION 2: REFERENCES SECTION 3: DEFINITIONS
17	SECTION 4: REQUIREMENTS Sec. 4.1 Materials
18	Sec. 4.2 Tube Size or Sheet Width Sec. 4.3 Marking
19	Table 1 Polyethylene tube and sheet sizes for push-on joint pipe* Sec. 4.4 Installation
24	SECTION 5: VERIFICATION Sec. 5.1 Inspection and Affidavit of Compliance
25	SECTION 6: DELIVERY
27	APPENDIX A SECTION A.1: Soil Survey Tests and Observations
30	Table A.1 Soil-test evaluation
32	SECTION A.2: Soil-Test Evaluation
33	SECTION A.3: Uniquely Severe Environments