BS ISO 7902-1:2013
$142.49
Hydrodynamic plain journal bearings under steady-state conditions. Circular cylindrical bearings – Calculation procedure
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 42 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Section sec_1 Section sec_2 Section sec_3 Section sec_3.1 1 Scope 2 Normative references 3 Basis of calculation, assumptions, and preconditions |
| 8 | Section sec_3.2 Section sec_3.3 Section sec_3.4 |
| 9 | Section sec_3.5 Section sec_4 Section sec_4.1 Section sec_4.2 Section sec_4.3 Section sec_4.4 Section sec_4.5 4 Calculation procedure |
| 10 | Figure fig_1 Section sec_4.6 |
| 11 | Section sec_4.7 Section sec_5 5 Symbols and units |
| 12 | Section sec_6 Section sec_6.1 Figure fig_2 Table tab_1 6 Definition of symbols 6.1 Load-carrying capacity |
| 15 | Section sec_6.2 6.2 Frictional power loss |
| 16 | Section sec_6.3 Section sec_6.3.1 Section sec_6.3.2 Section sec_6.3.3 6.3 Lubricant flow rate |
| 17 | Table tab_a Figure fig_3 Section sec_6.4 6.4 Heat balance |
| 18 | Section sec_6.4.1 Section sec_6.4.2 |
| 19 | Section sec_6.5 6.5 Minimum lubricant film thickness and specific bearing load |
| 20 | Section sec_6.6 6.6 Operational conditions |
| 21 | Section sec_6.7 6.7 Further influencing factors |
| 22 | Figure fig_4 |
| 23 | Annex sec_A Annex sec_A.1 Annex A (normative) Calculation examples |
| 27 | Table tab_A.1 |
| 29 | Table tab_A.2 |
| 30 | Table tab_A.3 |
| 31 | Figure fig_A.1 Annex sec_A.2 |
| 32 | Figure fig_A.2 |
| 33 | Table tab_A.4 Annex sec_A.3 |
| 34 | Figure fig_A.3 |
| 35 | Table tab_A.5 |
| 37 | Table tab_A.6 |
| 38 | Reference ref_1 Reference ref_2 Reference ref_3 Reference ref_4 Reference ref_5 Reference ref_6 Reference ref_7 Reference ref_8 Reference ref_9 Reference ref_10 Reference ref_11 Reference ref_12 Reference ref_13 Reference ref_14 Reference ref_15 Reference ref_16 Bibliography |
