Shopping Cart

No products in the cart.

IEC 60404-9:2018

$33.15

Magnetic materials – Part 9: Methods of determination of the geometrical characteristics of electrical steel strip and sheet

Published By Publication Date Number of Pages
IEC 2018-11-28 38
Guaranteed Safe Checkout
Categories: , ,

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. Weā€™re here to assist you 24/7.
Email:[email protected]

IECĀ 60404-9:2018 specifies the measurement and test methods for the determination of the following geometrical characteristics of electrical steel strip and sheet:
ā€“Ā Ā Ā  edge wave (wave factor);
ā€“Ā Ā Ā  residual curvature;
ā€“Ā Ā Ā  edge camber;
ā€“Ā Ā Ā  deviation from the shearing line (internal stress);
ā€“Ā Ā Ā  burr height.
This document applies to electrical steel strip and sheet intended for the construction of magnetic circuits and corresponding to Classes B2, C21, C22 and C23 of IECĀ 60404-1.
This edition includes the following significant technical changes with respect to the previous edition:
a. revision of terms and definitions;
b. specification of the length of test specimens for the determinations of edge wave (wave factor) and edge camber;
c. addition of the horizontal method for the determination of residual curvature, and a note that informs about a safety concern of the vertical method;
d. clarification that the burr height was characterized by the maximum value;
e. addition of the measuring procedure using a hand-held micrometer to determine the burr height.

IEC 60404-9:2018
$33.15