IEEE 430 2017
$33.04
IEEE Standard Procedures for the Measurement of Radio Noise from Overhead Power Lines and Substations
Published By | Publication Date | Number of Pages |
IEEE | 2017 | 34 |
New IEEE Standard – Active. Uniform procedures for the measurement of radio noise generated by corona from overhead power lines and substations are established in this standard. Measurement procedures in this standard are also valid for otherre power-line noise sources such as gaps and harmonics; however, most of the precautionary information, analysis, and data plotting techniques were written and developed primarily for corona discharges. The procedures are not valid for measuring transient radio noise sources that occur during breaker or disconnect switching operations. The procedures apply in the frequency range of 0.010 MHz to 1000 MHz; however, the emphasis is on the standard amplitude-modulation broadcasting (0.535 MHz to 1.605 MHz) and television broadcasting (54 MHz to 72 MHz, 76 MHz to 88 MHz, 174 MHz to 216 MHz, and 470 MHz to 698 MHz) bands. This standard is applicable to both ac and dc transmission lines and substations.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 430™-2017 Front cover |
2 | Title page |
4 | Important Notices and Disclaimers Concerning IEEE Standards Documents |
7 | Participants |
9 | Introduction |
10 | Contents |
11 | 1. Scope 2. Normative references |
12 | 3. Definitions 4. Measuring instrumentation 4.1 Radio-noise and field-strength meter |
13 | 4.2 Radio-noise meter calibration 4.3 Detector function selection 4.4 Units of measurements 4.5 Monitoring 5. Measurement of radio noise (0.010 MHz to 30 MHz) from overhead power lines 5.1 Test sites |
14 | 5.2 Measurement procedure |
17 | 5.3 Background data |
21 | 6. Measurement of radio noise (30 MHz to 1000 MHz) from overhead power lines 6.1 Introduction 6.2 Test sites 6.3 Measurement procedure |
25 | 7. Precautions in measurements 7.1 Location of personnel and equipment 7.2 Standing waves 7.3 Background noise 7.4 Weather |
26 | 7.5 Selection of antennas |
27 | 7.6 Additional precautions 8. Measurement of radio noise (0.010 MHz to 30 MHz) from substations 8.1 Test sites 8.2 Measurement procedure |
28 | 8.3 Reporting of data 9. Measurement of radio noise (30 MHz to 1000 MHz) from substations 9.1 Introduction |
29 | Annex A (informative) Bibliography |
30 | Annex B (informative) Vehicle-mounted antennas B.1 General B.2 Measuring broadcast signals B.3 Measuring radio noise |
31 | Annex C (informative) Application of measured signals and noise in transmission line design C.1 General C.2 Comparison pre- and post-construction C.3 Determining expected reception effects |
34 | Back cover |