{"id":522232,"date":"2024-11-05T15:07:19","date_gmt":"2024-11-05T15:07:19","guid":{"rendered":"https:\/\/pdfstandards.shop\/product\/uncategorized\/csa-z240-mh-series-16-r2021\/"},"modified":"2024-11-05T15:07:19","modified_gmt":"2024-11-05T15:07:19","slug":"csa-z240-mh-series-16-r2021","status":"publish","type":"product","link":"https:\/\/pdfstandards.shop\/product\/publishers\/csa\/csa-z240-mh-series-16-r2021\/","title":{"rendered":"CSA Z240 MH SERIES-16 (R2021)"},"content":{"rendered":"

Preface<\/strong><\/p>\n

<\/p>\n

This is the fourth edition of the CSA Z240 MH Series of Standards, Manufactured homes<\/em>. It supersedes the previous edition, published in 2009, and in 1992 and 1986 under the title Mobile Homes.<\/p>\n

<\/p>\n

Significant changes since the previous edition include the following:<\/p>\n

<\/p>\n

a) In CSA Z240.0.1, General requirements for manufactured homes:<\/p>\n

<\/p>\n

i) transfer of technical requirements that reference codes to CSA Z240.2.1;<\/p>\n

<\/p>\n

ii) deletion of provisions duplicating requirements in CSA Z240.2.1; and<\/p>\n

<\/p>\n

iii) reference to CSA A277 for marking and installation instructions.<\/p>\n

<\/p>\n

b) In CSA Z240.2.1, Structural requirements for manufactured homes:<\/p>\n

<\/p>\n

i) revision of title to recognize the scope of the standard;<\/p>\n

<\/p>\n

ii) elimination of unnecessary duplication and some further alignment with the requirements of the National Building Code of Canada (NBC), through a general reference to the NBC and retention of specific provisions as necessary to address issues particular to manufactured homes; and<\/p>\n

<\/p>\n

iii) updating and addition of requirements to improve the energy efficiency of manufactured homes.<\/p>\n

<\/p>\n

c) In CSA Z240.4.1, Installation requirements for gas- and oil-burning appliances in manufactured homes:<\/p>\n

<\/p>\n

i) expansion of scope to include requirements for oil-burning appliances to avoid duplication of many provisions; and<\/p>\n

<\/p>\n

ii) retention of provisions only as necessary to address issues particular to manufactured homes.<\/p>\n

<\/p>\n

d) In CSA Z240.5.1, Installation requirements for oil-burning appliances in manufactured homes:<\/p>\n

<\/p>\n

i) withdrawal; and<\/p>\n

<\/p>\n

ii) provisions necessary to address issues particular to manufactured homes moved to CSA Z240.4.1.<\/p>\n

<\/p>\n

e) In CSA Z240.9.1, Load calculation and duct design requirements for heating and cooling of manufactured homes:<\/p>\n

<\/p>\n

i) withdrawal; and<\/p>\n

<\/p>\n

ii) provisions necessary to address issues particular to manufactured homes moved to CSA Z240.2.1.<\/p>\n

<\/p>\n

——————————————————————————————————————————–<\/p>\n

<\/p>\n

Z240.0.1-16 – General requirements for manufactured homes<\/strong><\/p>\n

<\/p>\n

Scope<\/strong><\/p>\n

<\/p>\n

1.1<\/p>\n

This Standard specifies general requirements for manufactured homes, including technical requirements, and requirements on quality control, markings, and provision of printed instructions.<\/p>\n

<\/p>\n

1.2<\/p>\n

In this Standard, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; should is used to express a recommendation or that which is advised but not required; and may is used to express an option or that which is permissible within the limits of the Standard.<\/p>\n

<\/p>\n

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.<\/p>\n

<\/p>\n

Notes to tables and figures are considered part of the table or figure and may be written as requirements.<\/p>\n

<\/p>\n

Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.<\/p>\n

<\/p>\n

——————————————————————————————————————————–<\/p>\n

<\/p>\n

Z240.2.1-16 – Technical requirements for manufactured homes<\/strong><\/p>\n

<\/p>\n

Scope<\/strong><\/p>\n

<\/p>\n

1.1<\/p>\n

This Standard specifies the minimum requirements for materials, products, equipment, and practice needed to ensure that manufactured homes will provide adequate<\/p>\n

<\/p>\n

a) structural strength and rigidity, including resistance to vibration and deflection;<\/p>\n

<\/p>\n

b) protection against corrosion, decay, insects, and other similar destructive forces;<\/p>\n

<\/p>\n

c) protection against the hazards of fire;<\/p>\n

<\/p>\n

d) safety in use;<\/p>\n

<\/p>\n

e) resistance to unwanted entry;<\/p>\n

<\/p>\n

f) indoor conditions;<\/p>\n

<\/p>\n

g) sanitation; and<\/p>\n

<\/p>\n

h) thermal, HVAC and plumbing system performance to avoid excessive energy use.<\/p>\n

<\/p>\n

1.2<\/p>\n

The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only.<\/p>\n

<\/p>\n

1.3<\/p>\n

In this Standard, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; should is used to express a recommendation or that which is advised but not required; and may is used to express an option or that which is permissible within the limits of the Standard.<\/p>\n

<\/p>\n

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.<\/p>\n

<\/p>\n

Notes to tables and figures are considered part of the table or figure and may be written as requirements.<\/p>\n

<\/p>\n

Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.<\/p>\n

<\/p>\n

——————————————————————————————————————————–<\/p>\n

<\/p>\n

Z240.4.1-16 – Installation requirements for oil- and gas- fired appliances in manufactured homes<\/strong><\/p>\n

<\/p>\n

Scope<\/strong><\/p>\n

<\/p>\n

1.1<\/p>\n

This Standard applies to the factory installation of oil- and gas-fired appliances, equipment, components, accessories, piping and tubing in manufactured homes, and specially designed or modified units.<\/p>\n

<\/p>\n

Note: Specially designed or modified units include industrial or commercial trailers.<\/p>\n

<\/p>\n

1.2<\/p>\n

In this Standard, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; should is used to express a recommendation or that which is advised but not required; and may is used to express an option or that which is permissible within the limits of the Standard.<\/p>\n

<\/p>\n

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.<\/p>\n

<\/p>\n

Notes to tables and figures are considered part of the table or figure and may be written as requirements.<\/p>\n

<\/p>\n

Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.<\/p>\n","protected":false},"excerpt":{"rendered":"

Manufactured homes (Including revision history of 2019)<\/b><\/p>\n\n\n\n\n
Published By<\/td>\nPublication Date<\/td>\nNumber of Pages<\/td>\n<\/tr>\n
CSA<\/b><\/a><\/td>\n2016-03-01<\/td>\n71<\/td>\n<\/tr>\n<\/tbody>\n<\/table>\n","protected":false},"featured_media":522236,"template":"","meta":{"rank_math_lock_modified_date":false,"ep_exclude_from_search":false},"product_cat":[2674],"product_tag":[],"class_list":{"0":"post-522232","1":"product","2":"type-product","3":"status-publish","4":"has-post-thumbnail","6":"product_cat-csa","8":"first","9":"instock","10":"sold-individually","11":"shipping-taxable","12":"purchasable","13":"product-type-simple"},"_links":{"self":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product\/522232","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product"}],"about":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/types\/product"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media\/522236"}],"wp:attachment":[{"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/media?parent=522232"}],"wp:term":[{"taxonomy":"product_cat","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_cat?post=522232"},{"taxonomy":"product_tag","embeddable":true,"href":"https:\/\/pdfstandards.shop\/wp-json\/wp\/v2\/product_tag?post=522232"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}