BS EN 6037:2015

$102.76

Aerospace series. Fibre reinforced plastics. Test method. Determination of bearing strength

Published By	Publication Date	Number of Pages
BSI	2015	18

Guaranteed Safe Checkout

Categories: 49.025.40 - Rubber and plastics, BSI

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This European Standard defines the procedure to be used to determine the bearing strength of fibre composites with multidirectional reinforcement. This standard is applicable to composite laminates manufactured from unidirectional tape or woven fabric reinforcement.

This standard does not give any directions necessary to meet health and safety requirements. It is the responsibility of the user of this standard to consult and establish appropriate health and safety precautions.

PDF Catalog

PDF Pages	PDF Title
6	1 Scope 2 Normative references 3 Terms and definitions bearing stress at a given moment during the test 3.2 yield bearing strength 3.3 ultimate bearing strength
7	4 Principle of the method 5 Designation of the method 6 Apparatus 6.1 Tensile testing machine, calibrated to maintain a load and displacement accuracy in tension within 1 %. There shall be the capability to record load-elongation diagrams. 6.2 A chamber adapted to the machine to carry out tests at a specified temperature. The chamber temperature shall be controlled to within ( 3 C. 6.3 A timer. 6.4 A thermocouple with recorder if tests at temperatures other than ambient are required. 6.5 A flat-anvil micrometer with 6 mm diameter faces, accurate to within 0,01 mm. 6.6 An extensometer (gauge length of 50 mm recommended) or other equivalent strain measuring device to record elongations in terms of the applied load, accurate to within 1 % in the load range used. 7 Test specimen 7.1 Test specimen preparation
8	7.2 Tabs 7.3 Number of test specimen 7.4 Ageing of specimen 8 Procedure 8.1 Conditioning 8.2 Determination of specimen dimensions 8.3 Testing
9	8.4 Elevated and sub-zero temperature test 9 Presentation of the results 9.1 Bearing strengths
10	9.2 Types of failure 10 Test report 10.1 Complete identification of the material tested, including at least type, source, manufacturer’s code number, form, fibre areal mass, filament count, processing details, stacking sequence, test orientation. 10.2 All details about specimen preparation (including when applicable: tab material, tab adhesive and curing condition of this adhesive). 10.3 The measured specimen dimensions. 10.4 Ageing and/or exposure conditions prior to the test. 10.5 Date of test, facility and identification of individuals performing the tests. 10.6 Equipment, method and test parameters used. 10.7 Individual values, arithmetic mean and standard deviations per group of specimens of yield and ultimate bearing strengths, including relevant load-elongation curves. 10.8 Failure type per specimen (see Figures 3 to 7). 10.9 Any incident which may have affected the results and any deviation from this standard.

Additional information

Status	Definitive
Pages	18
Publication Date	2015-11-30
ISBN	978 0 580 86341 7
Standard Number	BS EN 6037:2015
Title	Aerospace series. Fibre reinforced plastics. Test method. Determination of bearing strength
Identical National Standard Of	EN 6037:2015
Descriptors	Fibres, Reinforcing materials, Specimen preparation, Air transport engineering, Plastics, Reinforced materials
Publisher	BSI
Committee	ACE/65
ICS Codes	49.025.40 - Rubber and plastics

Preview PDF


PDF Format	Searchable	Printable	Preview Now

BS EN 6037:2015

PDF Catalog

Related products