IEEE 1675 2009
$58.50
IEEE Standard for Broadband Over Powerline Hardware
Published By | Publication Date | Number of Pages |
IEEE | 2009 | 47 |
New IEEE Standard – Active. The scope of this standard is to provide testing and verification standards for the commonly used hardware, primarily couplers and enclosures, for broadband over power line (BPL) installations, and provide standard installation methods to enable compliance with applicable codes and standards. This standard does not cover repeater/node hardware, data transmission, protocols, or other aspects of BPL related to the internal workings of this technology.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 1675-2008 Front cover |
3 | Title page |
4 | Acknowledgments |
6 | Introduction Notice to users Laws and regulations Copyrights |
7 | Updating of IEEE documents Errata Interpretations Patents |
8 | Participants |
10 | Contents |
13 | Important notice 1. Overview 1.1 Scope 1.2 Purpose 2. Normative references |
15 | 3. Definitions, acronyms, and abbreviations 3.1 Definitions |
16 | 3.2 Acronyms and abbreviations 4. BPL networks typical installations |
19 | 5. Normal and special service conditions 5.1 General 5.2 Normal altitude and temperature service conditions for couplers 5.3 Unusual temperature and altitude service conditions |
20 | 5.4 Effect of air density on flashover voltage 5.5 Power frequency 5.6 Coupler isolation 5.7 System grounding 5.8 Insulating liquids |
21 | 5.9 Requirements for external insulation 6. Requirements, ratings, and tests 6.1 General requirements for all coupler types |
23 | 6.2 Coupler requirements |
25 | 6.3 Coupler type (design) tests |
31 | 6.4 Routine electrical tests 6.5 Common special tests |
32 | 7. Mechanical strength tests 7.1 General 7.2 Mechanical strength type (design) tests |
33 | 7.3 Mechanical strength special test 8. Product marking 9. Installation 9.1 General installation considerations |
34 | 9.2 General maintenance considerations 10. Installation procedures 10.1 General 10.2 Overhead medium-voltage couplers |
39 | 10.3 Pad-mount and underground locations |
44 | 10.4 Installation of backbone gateway equipment |
46 | Annex A (informative)Bibliography |
47 | Annex B (informative)Installation method to minimize faulty inductive coupler hazard |