IEC 62442-1:2011 defines a measurement and calculation method of the total input power for controlgear – lamp circuits when operating with their associated fluorescent lamp(s). The calculation method for the efficiency of the lamp controlgear is also defined. This International Standard applies to electrical controlgear lamp circuits consisting only of the controlgear and the lamp(s). It is intended for use on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz.<\/p>\n
| PDF Pages<\/th>\n | PDF Title<\/th>\n<\/tr>\n | ||||||
|---|---|---|---|---|---|---|---|
| 6<\/td>\n | English \n CONTENTS <\/td>\n<\/tr>\n | ||||||
| 7<\/td>\n | 1 Scope 2 Normative references <\/td>\n<\/tr>\n | ||||||
| 8<\/td>\n | 3 Terms and definitions <\/td>\n<\/tr>\n | ||||||
| 10<\/td>\n | 4 General 4.1 Applicability 4.2 Declaration of ballast lumen factor 4.3 Dimmable controlgear 4.4 Multi-wattage and\/or multi-lamp controlgear 4.5 Accuracy of measurement 4.6 Sampling of controlgear for testing <\/td>\n<\/tr>\n | ||||||
| 11<\/td>\n | 4.7 Number of samples 4.8 Conditioning of lamps 4.9 Test voltages and frequencies 5 Method of measurement and calculation of total input power of controlgear\u00a0\u2013lamp circuits and the efficiency of controlgear 5.1 Correction for ballast lumen factor 5.2 Method of measurement Table 1 \u2013 Typical nominal electricity supply details for some regions <\/td>\n<\/tr>\n | ||||||
| 12<\/td>\n | 5.3 Measurement and calculation of the total input power of magnetic wire wound controlgear \u2013 lamp circuits 5.4 Calculation of the efficiency of magnetic wire wound controlgear 5.5 Measurement and calculation of the total input power of electronic controlgear\u00a0\u2013lamp circuits <\/td>\n<\/tr>\n | ||||||
| 14<\/td>\n | 5.6 Calculation of the efficiency of electronic controlgear 5.7 Measuring the standby power Figures \n Figure 1 \u2013 Configuration of lamp and photocell sensor <\/td>\n<\/tr>\n | ||||||
| 15<\/td>\n | Annex A (normative) \nEnergy performance measurement setup Figure A.1 \u2013 Measurement of magnetic wire wound controlgear \u2013 lamp circuits <\/td>\n<\/tr>\n | ||||||
| 16<\/td>\n | Figure A.2 \u2013 Measurement of a.c. supplied electroniccontrolgear \u2013 lamp circuits Figure A.3 \u2013 Test setup for measuring standby power <\/td>\n<\/tr>\n | ||||||
| 17<\/td>\n | Figure A.4 \u2013 Side view of light output measurement system Figure A.5 \u2013 Top view of light output measurement system <\/td>\n<\/tr>\n | ||||||
| 19<\/td>\n | Annex B (informative) \nApplication of the reference ballast whenassessing lamps in electronic operation <\/td>\n<\/tr>\n | ||||||
| 20<\/td>\n | Bibliography <\/td>\n<\/tr>\n<\/table>\n","protected":false},"excerpt":{"rendered":" Energy performance of lamp controlgear – Controlgear for fluorescent lamps. Method of measurement to determine the total input power of controlgear circuits and the efficiency of the controlgear<\/b><\/p>\n |